Filter
Top Products
Care and Cleaning.
Do not use harsh detergents or abrasive
cleaners.
Do not place any part of this appliance in the
dishwasher.
Wipe the base with a clean cloth or paper towel.
Wash the water jug in warm soapy water using
a mild detergent.
Do not immerse the base in water or any other
liquid.
Do not wipe the base with a used kitchen cloth,
as this could contaminate it with bacteria.
Sunbeam is a Registered trademark. Pure Source trademark
pending. Made in China. Due to minor changes in design or
otherwise, the product you buy may differ from the one
shown in this booklet. Approved by the appropriate Electrical
Supply Authorities. Backed by Sunbeam’s 12 Month
Replacement Guarantee and National Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2001.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on any Sunbeam products,
contact the Sunbeam Consumer Service Line on 1800 025 059
in Australia. In New Zealand - contact the Sunbeam Office in
Auckland on 09 912 0747.
Replacing the Filter.
Handy Hints.
If the motor is running but no water comes out
of the spout, it may be necessary to purge all
the air from the system. To do this simply
remove the water jug and hold down the white
plunger in the centre of the base for
approximately 5 seconds, or until air bubbles
appear.
If this is not successful your filter requires
replacing. See Replacing the Filter section above.
Always push the reset button when fitting a
new replacement filter cartridge.
Removing the filter
Switch off and unplug the appliance.
Remove the water jug.
Remove and discard the old filter.
If black O-ring seals remain inside the appliance
remove and discard them.
Installing the filter
Remove the two red plugs from the new filter.
Wet the new O-ring seals and snap the filter
into place.
Flush the filter as explained in Flushing the Filter
Plug the appliance in and press the Reset
button.
Note: The Electronic Safety Monitor and Auto
Shut-Off features will not function properly if
you fail to reset the appliance after changing
the filter. Always ensure that you push the reset
button each time you change the filter.
Do not push the reset button at any other time
except when installing a new filter.
If your local retailer does not have replacement
filters available, free call Sunbeam Corporation
Ltd on 1800 025 059 for your nearest stockist.