Filter
Top Products
16
Models 150, 152, 162, 168Operating Procedures
Step 6
Install the draw valve handle. Insert the valve lifter arm
through the slotted opening in the draw valve and align
the other end with the cross holes of the freezer door.
Hint: The valve lifter arm may be aligned with the left
or right cross hole. The draw valve handle will be
placed through the opposite cross hole of the valve
lifter arm.
Figure 15
Slide the o-ring into the groove on the dr aw valve
handle and lubricate with Taylor Lube.
Figure 16
Insert the draw valve handle through the opposite
cross hole and into the opening of the valve lifter arm.
Hint: The draw valve handle can be assembled at
varied vertical positions. Choose an angle which is
comfortable for you. The draw valve must be raised
completely when the draw valve handle is down.
Figure 17
Figure 18
Note: For Models 162/168, slide the o-ring onto each
pivot pin and lubricate with Taylor Lube.
Figure 19