Filter
Top Products
ENGLISH
3130
Telescopic Guides
Sliding supports that help you to remove the
accessories from the oven guaranteeing their
handling without these tilting.
Catalytic Panels
They have a rough finish that allows self-
cleaning to be carried out. (See the section on
cleaning).
Turnspit
For the installation and handling of the
turnspit, refer to the characteristics sheet of
your oven. We recommend you to place the
tray beneath to collect the fat and juices.
Door Switch
On opening the door, the elements and fan
inside the oven are automatically switched off.
When the door is closed again, the oven
resumes working at the selected settings.
Tray Handle
The tray handle is used when you need to
move the tray to check the cook. To handle the
tray out the oven, you need to use gloves to
protect yourselve.
Crystal Clean Enamel
Special enamel which allows a main facility of
oven cleaning.
Cleaning and Maintenance
Caution
To carry out any action, the appliance must be
disconnected from the mains electricity supply.
• Clean the inside of the oven to eliminate
food and grease residues, which can give
off smoke or odours and cause stains to
appear.
•With the oven cold and for enamelled
surfaces (e.g. the floor of the oven) use
nylon brushes or sponges with warm soapy
water. If using special oven cleaning
products, use only on enamelled surfaces
and following the manufacturer’s
instructions.
Caution
Do not clean the inside of your oven with a
steam or pressurised water jet. Do not use
either metallic scouring pads or any material
that could scratch the enamel.
• Most models have a catalytic cleaning
system (self-cleaning). This system
eliminates small grease residues during
cooking at high temperatures.
• If grease residues remain after cooking,
these can be eliminated with the oven
empty at 250ºC for one hour.
Use of the Fold-down Grill (Depending on
Model)
To clean the upper part of the oven,
•Wait until the oven is cold.
•Turn the screw (A) and lower the grill
element as far as possible.
• Clean the upper part of the oven and return
the grill element to its initial position.
Cleaning the Inside of the Oven
If the food remains resist normal cleaning
(self-cleaning), then:
1 Remove the panels and leave them to soak
as long as is necessary to soften the food
residues.
2 Clean the panels, wiping them with a
sponge and clean water.
3 Dry the panels and re-assemble them in the
oven.
4 Connect the oven for one hour at 250ºC.
Caution
Do not use commercial cleaning products or
abrasive powders on catalytic panels.
Instructions for Removing the Catalytic Side
Panels with Tray Guides.
1 Remove the accessories from inside the
oven.
2 Loosen the bolt (A) and easing the panels
outwards, remove them from their location.
Cleaning the Catalytic Panels
A