Filter
Top Products
INSTALLATION WITH A THERMOVENTI-
LATED OVEN UNDER THE HOB
The oven should be installed according to
the corresponding manual.
If installing over a thermoventilated oven,
please remember that this hob has been
certified to work only with TEKA brand
ovens.
An opening of 20 mm should be made in
the back part of the kitchen unit so that
cold air is able to enter (see figure 1).
It is advisable not to use the
induction hob during the pyrolitic clea-
ning function in the case of the pyrolitic
ovens, due to the high temperature rea-
ched by this appliance.
When hobs are handled before
being installed, care should be taken in
case there is any protruding part or
sharp edge which could cause injury.
When installing units or applian-
ces above the hob, the hob should be
protected by a board so that the glass
cannot be damaged by accidental
blows or heavy weight.
The glues used in manufacturing
the kitchen unit and on the decorative
laminates and on the laminates that are
part of the worktop surface should be
made to tolerate temperatures of up to
100ºC.
TEKA does not assume any res-
ponsibility for any malfunction or
damage caused by faulty installation.
PLEASE REMEMBER THAT THE GUA-
RANTEE DOES NOT COVER THE
GLASS IF IT SUFFERS A VIOLENT
BLOW OR IF IT IS USED IMPROPERLY.
Fixing the hob
When the gap has been properly sized,
the gasket should be put on the lower side
of the glass. Silicone should not be
applied between the glass and the unit
worktop because if it becomes neces-
sary to remove the hob from its posi-
tion, the glass could break when trying
to detach it.
To fasten the cooking top to the kitchen
unit, use four clips fastened to the existing
openings in the lower part of the body (two
in front and two in back). There are two
possible ways to position the clips, as can
be seen in figure 2.
Depending on the thickness of the worktop,
it is possible to use the self-tapping screws
that are provided as a fastening accessory
by putting them into the clip's round hole.
This hole will be threaded as the screw is
inserted into it. This should be done before
fixing the clip to the worktop.
Connecting the electricity
The electric connection is made using an
omnipolar switch or plug, where accessi-
ble, that is suitable for the intensity to be
tolerated and that has a minimum gap of 3
GB
16
Sealing washer
Sealing washer
fig. 2