Thermador 423 Ventilation Hood User Manual


 
CARE & USE
HOODS and
VENTILATORS
5551 McFadden Avenue, Huntington Beach, CA 92649 • 800/735-4328
ECO 71566 • 19-08-963I • © Thermador Corporation 1998• Litho U. S. A. 11/00
Refer to installation instructions and consult your countertop supplier prior to
making counter opening. Consult with a heating and ventilating engineer for your
specific ventilation requirements.
For the most detailed information, refer to installation instructions accompany-
ing product or write Thermador indicating the model number.
Thermador reserves the right to change specifications or design without notice.
Some models are certified for use in Canada. Thermador is not responsible for
products which are transported from the United States for use in Canada.
Check with your local Canadian distributor or dealer. Thermador, 5551 McFadden
Avenue, Huntington Beach, CA 92649.
IMPORTANT SAFETY INSTRUCTIONS
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the manufacturer. If
you have any questions, contact the manufacturer.
B. Before servicing or cleaning unit, switch power off at service panel
and lock service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
CAUTION:
For General Ventilating Use Only. Do Not Use To Exhaust
Hazardous or Explosive Materials and Vapors.
WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE
a) Never leave surface units unattended at high settings. Boil-
overs cause smoking and greasy spillovers that may ignite.
Heat oils slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when
cooking flaming foods.
c) Clean ventilating fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
d) Use proper pan size. Always use cookware appropriate for
the size of the surface element.
WARNING - TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
A. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or other
metal tray, then turn off the gas burner or the electric element.
BE CAREFUL TO PREVENT BURNS. If the flames do not go out
immediately EVACUATE AND CALL THE FIRE DEPARTMENT.
CONTINUED ON NEXT PAGE
H64/65
Remove two (2) shipping screws from base of each lamp shade.
Lamp shade will now snap out for easy cleaning.
Install two (2) 75 Watt (maximum) flood lamps. For best results, use
reflector flood (not supplied with hood) into lamp shade sockets.
ON H65 ONLY
Install two (2) 250 Watt (maximum) infrared heat lamps, using type R-40
(not supplied with hood), into angled sockets only.
CLEANING – CONTINUED FROM PREVIOUS PAGE
Do not use scouring powders or abrasive cleaners on the hood as
these may permanently mar the finish. Do not use oven cleaners to
clean the stainless steel hood even if recommended by the manufac-
turer of the cleaner.
CAUTION