Thermador CVS45R Ventilation Hood User Manual


 
PAGE 5
1
2
3
0
CARE AND CLEANING
To Re-Assemble the Intake
1. Place the filters inside the intake, side by side, on
the slats in front of the back wall. They will lean
forward and the tops of the outside two will rest
against the support bars.
Always use the mildest cleaner that will do the job. Use clean, soft cloths, sponges or paper towels.
Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks.
After cleaning, place all parts in their proper positions before using the Cook‘n’Vent
®
.
The cleaners recommended below indicate a type and do not constitute an endorsement. Use all products
according to package directions.
The efficiency of the Cook‘n’Vent
®
downdraft ventila-
tion system depends on the cleanliness of the intake
and filters. The frequency of cleaning depends on the
amount and type of cooking.
Do not use the ventilating system without the fil-
ters in place or with grease-laden filters or surfaces.
Mesh Filters
Top Cap for
Black/White
Aluminum
Top Cap for
Stainless
Steel
Front Panel
& Back Wall
A or D
C
B
E
UP/DOWN
Push-button,
Control Knob
Support Bar
Support Bar
A Anodized Top cap is not removable. Wash top and underside with hot sudsy water. Rinse and wipe dry or
apply Fantastic
®
or Formula 409
®
first to a clean sponge or paper towel and wipe clean. DO NOT
USE powdered cleansers or steel wool pads.
B Aluminum Clean filters in the dishwasher or by agitating in sudsy water. Ensure that there is no soil
trapped in the fine mesh. Dry the filters before reinstalling them.
C Plastic DO NOT REMOVE push-button or control knob. Wipe with a moist soapy sponge. Rinse and
dry.
D Painted Top cap is not removable. Wash top and underside with hot sudsy water. Rinse and wipe dry or
apply Fantastik
®
or Formula 409
®
first to a clean sponge or paper towel and wipe clean. DO
NOT USE powdered cleansers or steel wool pads.
E Stainless Wipe grease accumulation with a paper towel or sponge. Scrape heavy buildup with a plastic
spatula. Clean with a soapy sponge; rinse and dry. Always wipe or rub with grain. Wipe with
Fantastik
®
or Formula 409
®
sprayed onto a paper towel. If grease buildup is heavy, several
applications may be necessary.
Polish with Revere Ware
®
Metal Polish or Stainless Steel Magic
®
and a soft cloth. Remove
water spots with a cloth dampened with white vinegar. Use Revere Ware
®
Instant Stainless
Steel Cleaner to remove heat discoloration.
Back Wall
Slats
2. Holding the front panel at the top near the sides,
place bottom edge over front lower sill of the in-
take.
3. Keeping the panel vertical, hook the top of the front
panel to the intake.
To Clean the Intake
Intake must be in the raised position to clean.
1. Turn Off the blower ("O").
2. Grasp the removable front panel at the top near
the sides and pull up and then forward. Set aside.
3. Remove filters.