Thermador HGSW Ventilation Hood User Manual


 
CLEANING INSTRUCTIONS
Be sure lights are cool before cleaning
the hood.
To Clean Filter/s
It is recommended that the filters
be washed at least once a month;
they can be washed by hand or in
the dishwasher.
Drain water through edge holes and
let each filter dry thoroughly before
replacing it.
To Clean Hood Surface
For general care, wipe the outside
of the stainless steel, white, black or
glass hood with sudsy water or
household cleaners such as
Fantastic® or Formula 409®, rinse
well and dry with clean soft cloth to
avoid water marks.
Wipe and dry brushed stainless steel
in the same direction as the grain.
Do not use abrasive products.
To remove finger prints and give
added shine use spray cleaners such
as Stainless Steel Magic® and
Shimmer®
LIGHTS
NOTE: Disconnect the hood from
electricity and be sure the lights are
cool. If new lights do not operate,
check fuses (see page 7 Fuses) and be
sure lights are inserted correctly before
calling service.
OPERATING
INSTRUCTIONS - HOOD
The blower should be turned on for
about 5 minutes before cooking in order
to establish air currents upward through
the hood. Thus when heat, smoke,
moisture, grease and cooking odors are
produced, they will be carried outside
instead of drifting into other rooms.
Use the low speeds for normal use and
the higher speeds for strong odors or
fumes.
Drafts across the range or cooktop will
reduce the effectiveness of the hood.
Such drafts should be prevented when
possible.
FILTERS
The metal grease filters will last forever.
They are made of anodized aluminum
To Remove The Metal Grease
Filter/s
Disconnect the hood from
electricity.
for Models HSW, HCSW, HGSW
Push clips towards the center and
pull the filters downward. Fig. 1.
for Models HDW, HTSW
Push each handle towards the back
and pull downwards Fig. 2.
To Replace The Metal Grease
Filter/s
Reverse procedure.
Page 5