Filter
Top Products
Page 2
CONTROL PANEL
F
Light: Light ON-OFF button
OFF: Blower OFF button
LO: Blower speed button 1 (low)
MED: Blower speed button 2 (med)
HI: Blower speed button 3 (high)
HSB SERIES HOODS
Off : Pressing button once turns blower off and resets control.
Fan Speed : Pressing button once, from an off state, turns the blower
on low. Each successive press of the button increases the fan speed
until high where the fan cycles back to the low speed. The LEDs
above this button indicate the current fan speed. When the blower
is on, the corresponding LED is illuminated. 1 – Low
2 – Medium
3 – High
Delay Shut Off : Press to turn fan on high for 15 minutes. If the
blower is off when the delay button is pressed, the ventilator will
turn on to the high speed setting for 15 minutes. At the end of the
cycle the blower will turn off.
If the blower is on when the delay button is pressed, the blower runs
for 15 minutes at the current speed then turns off.
During a timed period, the LED above the Delay Shut Off button is
illuminated.
To interrupt a timed period, press Fan Speed or Off button.
Filter: After 40 hours of operation, the clean filter reminder LED
above this button will illuminate indicating that the filters need to
be cleaned. After cleaning, press this button for 3 seconds to reset
the 40-hour period and turn the LED off.
Light: This button controls the halogen lighting. The first press
turns the lights on. A second press dims the lights. A third press
turns the lights off.
Heat Lamp: The buttons marked L and R independently control
the left and right infrared heating lamps, turning the lights on or off.
HS SERIES HOODS
LIGHT OFF LO MED HI
Blower ON
indicator light
button