Filter
Top Products
1.800.735.4328 | THERMADOR.COM
59
PRO HaRmOny® RanGES 36-InCH GaS
models: PRG364GDH / PRL364GDH
PRO HaRmOny RanGES
InSTaLLaTIOn OPTIOnS
Thermador Pro Harmony® Ranges feature a bold,
professional design and a compact, 24-inch depth
profile that creates a seamless look within standard
cabinetry. These ranges can be installed in a wall or
island installation.
BaCkGuaRD
36-inch Thermador Pro Harmony Ranges require an
accessory backguard. Choices include a 9-inch low
backguard or a 22-inch high backguard with shelf.
Either backguard must be attached before sliding the
range into the final installed position. An island trim is
included for covering the backguard mounting flanges
for island installations, where there is a minimum of 12"
of horizontal clearance behind the island trim.
CauTIOn: To avoid possible burn or fire hazard, a
backguard designed specifically for this range must be
installed whenever the range is used.
naTuRaL GaS OR LP
Thermador All-Gas Pro Harmony Ranges are shipped
by the factory to operate on natural gas or LP. Be sure
to order the correct fuel-type and verify the type of gas
being used at the installation site matches the type of
gas used by the appliance.
ImPORTanT
We strongly recommend that a Thermador
Professional Wall or Island Hood or Custom Insert be
installed with all Thermador Pro Harmony Ranges.
Downdraft ventilation should not be used. Do not
install a microwave-hood combination above the
cooktop, as these types of units do not provide
the proper ventilation and are not suitable for use
with Thermador Pro Harmony Ranges. Refer to the
Ventilation section or www.Thermador.com for a
complete selection of Professional ventilation options,
blowers, and accessories.
Due to the high surface temperature output of the Pro
Harmony Ranges, the HPWB Professional Series Wall
Hoods or the Professional Series Custom Inserts are
recommended ventilation solutions for these ranges.
The PH Professional Series Wall Hoods are also a viable
option, however the 27" depth of the PH Series may
not be suitable to all applications.
36-INCH CUTOUT AND RANGE DIMENSIONS
*min.
30"-40"
36
"
19
13
/
16
"
8
1
/
8
"
3
3
/
16
"
**min. 10"
24"
Gas and Electric connections
27
1
/
4
"
35
15
/
16
"
27
5
/
8
"
44
7
/
8
"
24
3
/
4
"
23
"
35
7
/
8
"-
36
3
/
4
"
* 30" minimum clearance above cooking surface to
non-combustible surface. Minimum clearance above
cooking surface to combustible surface is 40".
** 10" minimum clearance from cooking surface to
combustible side walls.
note: Most hoods contain combustible components that
must be considered when planning the installation.
measurement in inches
measurement in inches