Filter
Top Products
PRG Professional Ranges Care and Use
See Installation Instructions for electrical requirements
and grounding instructions.
CAUTION - ALL MODELS
DO NOT UNDER ANY CIRCUMSTANCES CUT OR
REMOVE THE THIRD (GROUND OR NEUTRAL)
PRONG FROM THE POWER CORD PLUG (ALL-GAS
PRG RANGES).
It is the personal responsibility and obligation of you, the user, to have
this appliance connected to the electrical power supply in accordance
with the National Electrical Code and/or applicable local codes and
ordinances by a qualified electrician.
Electrical Requirements and Grounding Instructions
SECTION ONE: General Safety Instructions
SAFETY
Page 3
PLEASE READ
CAREFULLY
All-Gas Models:
PRG304, PRG364GD, PRG364GL,
PRG366, PRG484GG, PRG486GD,
PRG486GL
120 volts, 60 Hz., 20 Amp electrical
circuit required.
FOR PERSONAL SAFE-
TY, THIS APPLIANCE
MUST BE CONNECTED
TO A PROPERLY
GROUNDED AND PO-
LARIZED ELECTRICAL
POWER SUPPLY.
ALWAYS DISCONNECT THE
ELECTRICAL PLUG FROM THE
WALL RECEPTACLE BEFORE
SERVICING THIS UNIT.
It is recommended that a dedicated
circuit servicing this appliance be
provided.
CAUTION - ALL MODELS
In Case of an Electrical Failure
If for any reason a gas control knob is turned ON and there is no
electric power to operate the electronic igniters on the cooktop
burners, turn OFF the gas control knob and wait 5 minutes
for the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners manually, carefully hold a lighted match
to the burner ports and turn the gas control knob to HI. During a
power failure you can use the cooktop burners, but each must be lit
with a match.
DO NOT attempt to light the two left burners manually.
These burners are equipped with the ExtraLow
®
feature and
cannot be lit manually.
NOTE: For PRG All-Gas Ranges, the gas oven and broiler burners
cannot be lighted manually during a power failure.