Filter
Top Products
Built-in Oven Care and Use Manual
Do-It-Yourself Maintenance
Do-It-Yourself Maintenance
Fahrenheit to Celsius
The oven has been preset to a Fahrenheit tempera-
ture.
To change to Celsius, follow these steps:
I. Turn off ovens.
2. Touch and hold the START pad and then the
CONVECTION pad at the same time for
3 seconds.
3. “F” appears in the temperature digits; release both
pads.
4. Touch CONVECTION; “C” replaces “F.” This
alternates when CONVECTION is touched.
5. To complete the change, touch START.
Calibrating Oven Temperature
The electronic thermostat has been preset to 0°F and
accurately maintains its setting. If the browning re-
sults are too light or too dark for your preferences,
you can raise or lower the setting.
To change calibration of oven temperature for
single or upper ovens:
1. Turn off oven(s).
2. For single oven or upper oven, touch and hold
the START pad and then touch the BAKE pad.
3. “0” (zero) appears in the temperature digits; re-
lease all pads.
4. Touch BAKE and 0 changes in increments of 5
degrees each time it is touched. The maximum
adjustment is ± 35ºF. In Celsius the range is ±
3ºC to 21ºC.
5. To complete the change, touch START.
To change calibration of oven temperature for lower
oven on double ovens:
1. Touch the ROAST pad instead of the BAKE pad.
2. Continue with Steps 3 through 5, as described
above.
NOTE:
The available temperature range for this oven
is 100ºF to 550ºF. This applies to all conven-
tion cooking modes. A change in the cali-
bration does not affect Dehydrate, Proof or
Warm modes.
Volume
The volume of the beeps and beeps can be adjusted.
Touch and hold the START pad and the PROBE pad
for three seconds. Touch PROBE pad again to
increase or decrease volume, from levels 1 to 3. Touch
START to set volume selection.
32
Voltage Change Option
The oven has been preset for 240 VAC. If your resi-
dence has been supplied with 208 VAC, the oven
voltage can be changed during installation.
1. Turn both ovens off. Touch OVEN OFF for each
oven.
2. Touch and hold the START pad and the SELF
CLEAN pad at the same time for 3 seconds.
3. “240” appears in the display. Release both pads.
4. Touch the SELF CLEAN pad. “240” is replaced
with “208.” This alternates when SELF CLEAN is
touched.
5. To complete the change, touch START.
For authorized service or parts information, phone (800) 735-4328.
We want you to remain a satisfied customer. If a problem does come up that cannot be
resolved to your satisfaction write to Thermador Customer Support Call Center,
5551 McFadden Avenue, Huntington Beach CA, 92649 or call: 1-800-735-4328.
Please include the Model Number, Serial Number and Date of Original Purchase and
Installation.
How to Obtain Service