Filter
Top Products
Page 13
three or four studs as available.
Countersink the heads to pre-
vent interference with the
hood.
8. On the wood bracket mark the
locations used to hang the hood
according to Figure 7.
9. Drill a 1/8 tap hole through
the wooden bracket and drywall.
These screws do not need to go
into the studs.
10.Screw 2 (4.2mm x 18 mm)
screws into the wood bracket
leaving 1/4 of the screw ex-
posed for hanging the hood.
11.Discharge Direction: Horizon-
tal discharge requires a wall
cutout, as shown in Figure 1 of
this manual, to provide clear-
ance for the transition. The
location of the cutout is deter-
mined by the hood installation
height.
For Vertical discharge,please
refer to step 4, Page 10.
12.Hang the hood using slots I in
Figure 8. Make sure the wood
bracket fits into the recess on
the back of the hood.
13.Tighten the screws in slots I.
Use slots I to level the hood.
14.From inside the hood drive 4 or
6 screws depending on model
(4.2 mm x 18 mm) through holes
J into wooden bracket.
15. Drill a 3/8 tap hole through
the center of the holes K into
the wall. Insert two wall plugs
into drilled holes. Tighten hood
to wall anchors by installing 2
screws with washers.
J
I
K
Figure 8