Filter
Top Products
6
Installation procedure
Prepare cabinet cutout according figure 3 and install electrical connection.
Slide uĆshaped plastic part of antiĆtip assembly onto middle of channel at rear of
warming drawer as shown in figure 4.
Position bracket of antiĆtip assembly on floor of cabinet opening as shown in Figure
4 and attach with two torx head screws.
4
Insert plug into threeĆprong, grounded outlet. See Power requirements" for
electrical specifications.
Slide warming drawer assembly into cutout until it is flush with cabinet.
Note: Ensure that the connector lead doesn' t become trapped or bent.
Verify that antiĆtip assembly is properly installed by pulling down on the front of the
drawer. The bracket should hold the drawer in place.
Align the appliance flush with the units and secure it to cabinet through four screw
holes in front frame (drill pilot holes in cabinet first if necessary). Use torx head
screws included.
Prepare cabinet cutout
Install antiĆtip assembly
Connect to electricity
Install warming drawer