Filter
Top Products
5
one Coffee Measuring Scoop or a level tablespoon of ground coffee is
used for each cup of coffee. Adjust the amount to your personal taste.
3. Close the Filter Basket Holder and snap into place. NOTE:
If the door
does not close completely, check to see that the Filter Basket and
Permanent Coffee Filter are properly seated in the Filter Basket Holder
then snap the door into place.
4. Place the Carafe with Lid on the Keep Warm Plate.
5. Plug into a 120 Volt AC outlet
6. Set the current time on the clock by pressing the PROG Button once.
Press the Hour Button to set the hour then press the MIN Button
to set the minutes.
7. Press the PROG Button once again to set the time for the Delayed
Brew Cycle. Press the Hour Button to set the hour and then press
the MIN Button to set the minutes.
8. Press the ON/OFF Button twice and the green AUTO light will illuminate.
After about 10 seconds the Digital Display will switch back to the current
time. To see the Delayed Brew start time press the PROG Button once.
9. Once the clock reaches the preset time to start the Brew Cycle, the green
AUTO Indicator Light will go out and the red ON Indicator Light will
illuminate and the brew cycle will start.
10. After the brew cycle is finished, the Coffee Maker will automatically
switch over to ‘Keep Warm’ mode for the next two hours. The ‘Keep
Warm Cycle’ will shut off automatically and the ‘On’ Indicator Light
will go out at the end of the 2 hours. If you wish to turn off the Coffee
Maker before 2 hours has elapsed, press the ON/OFF Button once.
‘PAUSE & SERVE’ FEATURE
The ‘Pause & Serve’ feature allows you to pour a cup of coffee before
the brew cycle has finished. Remove the Carafe slowly to temporarily
stop the flow of coffee. Quickly pour a cup of coffee and reposition
the Carafe securely on the Keep Warm Plate. NOTE: DO NOT remove
the Carafe for longer than 30 seconds.