Filter
Top Products
5.4.
Before Using Your Electric Kettle
Please fill out information that follows warranty.
CAUTION: Do not immerse kettle or power base in water or any
other liquid or put in a dishwasher to clean.
Thoroughly clean your kettle before using by filling the kettle with the
maximum 2 liters (8
1
⁄
3
cups) of water and boil. SEE BOILING
INSTRUCTIONS. When unit shuts off, discard the water. Wait 10 minutes
to allow heating elements to cool. Repeat the process one more time.
Getting to Know your Electric Kettle
Kettle Use and Care Guide
Boiling Instructions
1. Remove kettle from power base.
2. Place power base on a level counter.
3. Press the switch to the OFF position.
4. Tilt the lid open by lifting up. Fill the kettle with the desired
amount of water using the water level indicator. Make sure that
the 0,5 litres (2
1
⁄
8
cups) minimum and 2,0 litres (8
1
⁄
8
cups)
maximum amounts are observed. Close the lid and wipe excess
water off the outside of kettle and power base. The lid must be
closed to avoid contact with hot steam when grasping the handle
and for the automatic shut off to work.
NOTE: Tilt lid open only when the kettle is cold.
5. Carefully place the kettle on the power base engaging the
connector into the bottom of the kettle. Do not tip the kettle as
you place it over the connector.
6. Plug power base into any 120 V ~ 60 Hz grounded electrical outlet.
7. Press the switch to the ON position; the indicator light at the
bottom of the handle will come on.
WARNING: This appliance generates heat and escaping steam
during use. Use proper precautions to prevent the risk of burns,
fires, or other injury to persons or damage the property. Keep
hands and face clear of the area above the Kettle.
8. When the water comes to a boil, the kettle will turn off automatically
and the indicator light will turn off. The kettle may now be removed
for use. Carry the kettle very carefully and level to avoid spillage and
possible injury. The kettle may be placed on the countertop or table
for serving. At anytime while the kettle is heating, you may press the
switch to the OFF position and remove the kettle.
CAUTION: Do not touch hot surfaces!
NOTE: Always wait until the kettle has automatically shut off and the
indicator light is off, or press the switch to the OFF position before
removing from or placing the kettle onto the power base. If the OFF
switch is not pressed, and the kettle is removed from the power base,
the kettle will automatically turn off. If the kettle is dry and the ON
switch is turned on to boil, it will shut off automatically after a few
seconds but may result in damage to the unit.
0.5L
MIN
1.0L
1.5L
2.0L
MAX
0.5L
MIN
1.0L
1.5L
2.0L
MAX
Figure 1
Figure 2
Handle
Spout
Power Base
(P/N 30938)
Lid
On/Off
Switch
Water Level
Indicator