Filter
Top Products
4
BLENDER ASSEMBLY INSTRUCTIONS
NOTE: Before assembling, make sure the cord is unplugged and the
Control Dial is in (O) OFF position.
CAUTION: Use extreme care when handling the Blade Assembly.
Do not touch Blades with your fingers. The Blades are very
sharp and can cause injury if touched.
1. Carefully place the Rubber Seal Ring over the Blade Assembly.
2. Place the Blade Assembly in the Glass Blending Jar.
3. Place the Collar over the Blade Assembly. Hold the Glass
Blending Jar and turn the Collar clockwise to firmly secure it into
position on the Glass Blending Jar.
NOTE: The Collar and Blade must be firmly attached to the
Blending Jar before putting any foods or liquids into the
Blending Jar.
OPERATING INSTRUCTIONS
CAUTION: Keep hands and utensils out of the Blending Jar while
blending to prevent the possibility of severe injury to persons or
damage to the unit. A scraper may be used but must only be
used when the unit is not running.
CAUTION: Use extreme care when handling the Blade Assembly.
Do not touch Blades with your fingers. The Blades are very
sharp and can cause injury if touched.
1. Before starting, make sure power cord is unplugged and the
Control Dial is in (O) OFF position.
2. Make sure that the Blade Assembly, Rubber Seal Ring, and Collar
are properly assembled and securely fastened to the Blending Jar.
See Assembly Instructions for details.
3. Place the Blending Jar on top of the Motor Housing making sure
it is firmly seated and not tilting to one side.
CAUTION: Never place the Blade Assembly on the Motor Housing
without the Blending Jar being completely assembled and
securely tightened.
4. Add ingredients to the Glass Blending Jar and secure the
Blending Jar Lid.
NOTE: Do not fill the Glass Blending Jar more than 3/4 full, 4.5
cups (36-oz.). Never operate when the Blending Jar is empty.
5. Place Blending Jar Lid with Measuring Cap on Glass Blending Jar.
IMPORTANT: Always hold Lid in place during processing.
BEFORE USING FOR THE FIRST TIME
CAUTION: Use extreme care when handling the Blade Assembly.
Do not touch the Blades with your fingers. The Blades are very
sharp and can cause injury if touched.
1. Carefully unpack the Blender, Glass Blending Jar, and all parts.
2. Wash the Measuring Cap, Rubber Seal Ring, Glass Blending Jar,
Blending Jar Lid, and Blade Assembly in warm soapy water.
Rinse and dry thoroughly.
3. Make sure the cord is unplugged and the Control Dial is in the
(O) OFF position.
CAUTION: To protect against risk of electrical shock, do not place
Motor Housing, plug or cord in water or any other liquid.
4. Wipe the Motor Housing clean with a moistened cloth.
Dry thoroughly.
GETTING TO KNOW YOUR FARBERWARE
®
2 SPEED BLENDER
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
9.
8.
6.
1.
2.
3.
4.
5.
3
7.
1. Measuring Cap (P/N 71192)
2. Blending Jar Lid (P/N 71193)
3. Glass Blending Jar (P/N 71194)
4. Rubber Seal Ring (P/N 71195)
5. Blade Assembly (P/N 71196)
6. Collar (P/N 71197)
7. Motor Housing
8. Control Dial
9. Power Cord with
Polarized Plug
Control Dial
FBW_FBL500SS_IB_9-1-06 1/9/06 2:35 PM Page 7