Filter
Top Products
6
10. To reheat water, check the water level to ensure it is above the .75L
water level. If necessary, add more water, then place Kettle back onto
Power Base. Be careful not to spill any water onto the Power Base.
Press ON/OFF Lever down, into the ON (I) position.
CAUTION: When refilling, take care when lifting the Lid, as the Kettle,
if hot, may be full of steam. Keep your face, hands, etc. clear of
the opening.
11. Unplug the Power Base when not in use. Allow it to cool before reuse.
Empty the Kettle after each use. Do not leave water in the Kettle
overnight.
Boil-Dry Protection
A safety thermostat will automatically operate should your Kettle be
accidentally plugged in without any water, or if the Kettle is without
sufficient water, or if the Kettle is allowed to boil dry. To reset the boil-dry
protection device, you must remove the Kettle from the Power Base and
allow it to cool before refilling with water.
User Maintenance Instructions
This appliance requires little maintenance. It contains no user serviceable
parts. Do not try to repair it yourself. Any servicing requiring disassembly
must be performed by a qualified appliance repair technician.
Cleaning Your Electric Kettle
CAUTION: Do not immerse Kettle or Power Base in any liquid, or place
in a dishwasher to be cleaned.
1. Raise the ON/OFF Lever into the OFF (o) position and unplug unit.
Allow unit to cool before cleaning.
2. Open the Lid by pressing the Lid Release Button on the handle.
3. Remove the Scale Filter from inside the Kettle (located just
inside the spout). Firmly push the top of the Filter forward
to release, then pull straight up and out. (See Figure 3.)
Rinse under running water and use a soft brush if
necessary. (Do not use a metal brush.) Do not wash in
dishwasher. Place Scale Filter back into position.
4. Rinse inside of kettle with water and wipe it with a damp cloth.
NOTE: Do not use highly corrosive or abrasive cleaning agents or brushes.
5. Wipe the Power Base unit with a damp cloth.
NOTE: Mineral deposits can form a coating inside the Kettle and may
cause an off flavor in the water or lengthen the boiling time. Use
the following cleaning method:
6. In a bowl, mix a diluted solution of one part vinegar to four parts
water and pour into Kettle. Do not boil the solution in the Kettle, as it
may damage the Kettle.
7. Allow the solution to soak in the Kettle for 30 minutes. Then clean
with a soft, non-abrasive brush.
8. Empty out solution. Fill the Kettle with clean water
and rinse thoroughly.
Figure 3
1
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always
be followed, including the following:
1. Read all instructions.
2. Do not touch hot surfaces. Use handles or knobs.
3. To protect against fire, electric shock and injury to persons do not
immerse cord, plugs, or appliance in water or other liquid.
4. Close supervision is necessary when any appliance is used by or
near children.
5. Unplug from outlet when not in use and before cleaning. Allow
to cool before putting on or taking off parts, and before cleaning
the appliance.
6. Do not operate any appliance with a damaged cord or plug or after
the appliance malfunctions, or has been damaged in any manner.
Contact Consumer Service for examination, repair or adjustment.
7. The use of accessory attachments not recommended by the
appliance manufacturer may result in fire, electric shock or injury
to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch
hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a
heated oven.
11. To disconnect, raise the ON/OFF Lever into the OFF (o) position,
then remove plug from wall outlet.
12. Do not use appliance for other than intended use.
13. Be certain Lid is securely in place before operating appliance.
14. Scalding may occur if the Lid is removed during heating.
SAVE THESE INSTRUCTIONS
For household use only
RH_RHEKRET_IB_30-6-06 6/30/06 5:51 PM Page 3