Filter
Top Products
4
Before Using for the First Time
Carefully unpack Hand Mixer. Wash Beaters and Dough Hooks
in warm, soapy water. Rinse well and dry thoroughly. Wipe Motor
Housing with a soft, clean cloth or sponge. Never immerse the
Hand Mixer in water or any other liquid.
Using Your Hand Mixer
1. Make sure the Hand Mixer is unplugged.
2. Position the Speed Control Lever to “0,” the OFF position.
3. Attach Beaters or Dough Hooks, following the instructions in the
section named “Attaching Beaters” or “Attaching Dough Hooks.”
4. Plug into 120V AC outlet.
CAUTION: Operating the Hand Mixer for more than 5 minutes
at a time could cause the motor to overheat.
5. Place Beaters or Dough Hooks in container holding ingredients.
Slide the Speed Control Lever to the desired Speed Setting, “1”
being the lowest setting and “5” being the highest.
6. If you desire more speed on speed settings “1” through “5,” press
the Turbo Button to increase the speed for a short period of time.
CAUTION: To avoid overheating, do not use the Turbo Button for
more than 1 minute at a time.
7. When you are finished mixing ingredients, position the
Speed Control Lever to “0” and unplug Hand Mixer from the
electrical outlet.
Turbo
Your Hand Mixer has 5 different speed settings. The Turbo feature can
be used at any speed setting by depressing the Turbo Button. Resume
previously selected speed by releasing Turbo Button.
NOTE: DO NOT use Turbo feature for more than 1 minute at a time
as the Motor may overheat and damage the Hand Mixer.
Attaching Beaters
1. Make sure the Hand Mixer is
unplugged and the Speed
Control Lever is set to “0,”
the OFF position.
2. Align notches on Beaters
with slots on the bottom of
the Motor Housing, and push
until they click and lock into
place (see Figure 2).
CAUTION: Always unplug Hand Mixer before installing or removing
Beaters.
Figure 2
Getting to Know Your Russell Hobbs®
5-Speed Hand Mixer
Product may vary slightly from illustrations.
3
1. Motor Housing
2. Beaters (P/N 71228)
3. Dough Hooks
(P/N 71229 - without collar)
(P/N 71229C - with collar)
4. Collar
5. Cord with Polarized Plug
6. Handle
7. Beater Eject Button
8. Turbo Button
9. Speed Control Lever
1.
3.
2.
5.
4.
6.
7.
8.
9.
Figure 1