Filter
Top Products
5.
Before You Use Your Coffeemaker
Before preparing coffee in your new coffeemaker, thoroughly clean
the carafe, carafe lid and removable filter holder and permanent
filter in hot, sudsy water. Rinse and dry. Replace disassembled parts.
Clean the inside of the coffeemaker by brewing two full carafes of tap
water (see "Brewing Instructions" below). Do not place coffee in filter
holder for this initial cleaning.
Note: At the end of first cycle, turn coffeemaker off and wait ten
minutes. Turn unit on and brew second carafe of water.
Brewing Instructions
1. Plug coffeemaker into any 120 Volt, AC electrical outlet.
2. Fill carafe with cold tap water and pour into water chamber.
Markings on the carafe indicate level of water required to brew
desired number of cups. No less than two cups is recommended.
Note: The amount of brewed coffee will always be less than the
amount of water placed into coffeemaker, since about 10% is
absorbed by coffee grounds and filter.
3. Measure one level tablespoon of drip or regular grind coffee for
each cup of coffee desired. For stronger or milder coffee, adjust
amount of coffee to suit your taste. Add coffee to permanent filter
and place filter into filter holder.
4. Return filter holder to closed position.
5. Place carafe on warming plate.
6. Switch control to on.
7. If you wish to serve a cup of coffee before brew cycle is
completed, simply remove carafe from warming plate. Dripping
will automatically cease. Return carafe to position on warming
plate within a few seconds; dripping will resume.
TMR_TCM10PWF_IB_16-1-04 01/16/2004 16:19 Page 5