Filter
Top Products
3
GENERAL INSTALLATION DATA
This equipment is designed and sold for commercial use only by personnel trained and
experienced in its operation and is not sold for consumer use in and around the home nor for use
directly by the general public in food service locations.
Before using your new equipment, read and understand all the instructions & labels associated
with the unit prior to putting it into operation. Make sure all people associated with its use
understand the units operation & safety before they use the unit.
All shipping containers should be checked for freight damage both visible and concealed. This
unit has been tested and carefully packaged to insure delivery of your unit in perfect condition. If
equipment is received in damaged condition, either apparent or concealed, a claim must be made
with the delivering carrier.
Concealed damage or loss - if damage or loss is not apparent until after equipment is unpacked,
a request for inspection of concealed damage must be made with carrier within 15 days.
Be certain to retain all contents plus external and internal packaging materials for inspection.
The carrier will make an inspection and will supply necessary claim forms.
WARNING: Improper installation, adjustment, alteration, service or
maintenance can cause property damage, injury or death. Read the
installation, operating and maintenance instructions thoroughly before
installing or servicing the equipment.
This fryer is equipped for the voltage and wattage indicated on the nameplate mounted
on the underside of the front edge. It is designed for use on alternating current (AC)
only. It is intended for use by properly trained personnel only.
DO NOT CONNECT TO DIRECT CURRENT (DC)
The installation of the appliance should conform to:
NATIONAL ELECTRIC CODE AND ALL LOCAL ELECTRIC CODES AND
ORDINANCES AND THE LOCAL ELECTRIC COMPANY RULES AND
REGULATIONS
MODEL: TMFE15
Proper connections and power supply are essential for efcient performance. Connect six foot
lead in cord to a suitable grounded outlet of the correct voltage. Be sure the switch is in the off
position. The receptacle should match the plug (NEMA conguration of receptacle is: 6-30R).
MODEL: TMFE30
For your protection we recommend that a qualied electrician install this appliance. They should
be familiar with electrical installations and all electrical codes. Proper connections and power
supply are essential for efcient performance. The external wiring should be in conduit of an
approved type of exible cable suitable for operation at 194°F (90°C) and of a proper size to carry
the load.
Four legs are provided and should be installed for ease of cleaning. Level unit by adjusting the
(4) feet which have an adjustment of 1-3/8" (35 mm) for accurate leveling and perfect line-up with
other units.
POWER SUPPLY
The Model TMFE15 & TMFE30 is wired at the factory for operation on a single phase power
supply 208/240V, 60 Hz.
DO NOT INSTALL WITHOUT FEET.
PLACE THE LAMINATED WARNING SIGN SUPPLIED WITH THE FRYER IN AN
AREA VISIBLE TO THE FRYER OPERATOR.
CAUTION
WARNING
CAUTION