Filter
Top Products
CAUTION
This equipment is designed and sold for commercial use only by personnel trained and experienced
in its operation and is not sold for consumer use in and around the home nor for use directly by the
general public in food service locations.
Before using your new equipment, read and understand all the instructions & labels associated with
the unit prior to putting it into operation. Make sure all people associated with its use understand the
units operation & safety before they use the unit.
All shipping containers should be checked for freight damage both visible and concealed. This
unit has been tested and carefully packaged to insure delivery of your unit in perfect condition. If
equipment is received in damaged condition, either apparent or concealed, a claim must be made with
the delivering carrier.
Concealed damage or loss - if damage or loss is not apparent until after equipment is
unpacked, a request for inspection of concealed damage must be made with carrier within
15 days. Be certain to retain all contents plus external and internal packaging materials for
inspection. The carrier will make an inspection and will supply necessary claim forms.
INSTALLATION
The griddles are equipped for the voltage indicated on the nameplate mounted under the
bullnose on the front panel. They will operate on alternating current (AC) only.
WARNING
DO NOT CONNECT TO DIRECT CURRENT (DC).
The installation of the electric griddle should conform to the:
NATIONAL ELECTRIC CODE AND ALL LOCAL ELECTRIC CODES AND ORDINANCES AND
THE LOCAL ELECTRIC COMPANY RULES AND REGULATIONS
For your protection we recommend that a qualied electrician install this griddle. He should be
familiar with electrical installations and all electric codes. Proper connections and power supply are
essential for efcient performance. The external wiring should be in conduit or an approved type
of exible cable suitable for operation at the temperature indicated on the wiring diagram, and of a
proper size to carry the load. The supply circuit should be properly fused and equipped with a means
of disconnecting, as required by local electrical code. THE BODY OF THE GRIDDLE SHOULD BE
GROUNDED (DO NOT GROUND TO A GAS SUPPLY LINE).
GENERAL OPERATING PROCEDURES
The Toastmaster series electric griddles may be wired for operation in the eld for either 1-phase or 3-
phase power supplies by making line connections at the junction box(es) located at the rear of the unit.
Model TMGE36 should be wired for 3-phase power supply only. Two junction boxes are provided on
the TMGE48 for making line connections. These may be connected in parallel to one 16KW 3-phase
line or on two separate 8KW lines.
CONNECTING POWER SUPPLY
Detach cover on junction box at rear of unit. There are pigtail leads for the supply connection
in the junction box.
LOCATING AND LEVELING THE UNIT
Do not install the unit closer than 1-inch from a side wall and/or closer than 1-inch from a rear wall.
Level unit by adjusting the (4) feet which have an adjustment of 1-3/4” (43.75mm) for accurate leveling
and perfect line-up with other Star-Max series units.
WARNING
CAUTION