Filter
Top Products
Operating Instructions
Before First Use
1. Carefully unpack your Hot Pot and remove all packaging
materials.
2. To remove any dust that may have accumulated during
packaging, simply wipe the Hot Pot exterior with a clean, damp
cloth.
3. Do not use abrasive cleansers.
4. Do not put the Hot Pot, cord, or plug in water.
5. Boil one full Hot Pot of water following the Instructions For Use.
6. Rinse the Hot Pot out with cold water. Wash the Lid in warm,
soapy water, rinse, and then dry thoroughly.
Instructions For Use
1. Place Hot Pot on a flat, heat-resistant surface.
2. Fill the Hot Pot with 8 to 32 (1 to 4 cups) of liquid or food.
3. Lower the Lid onto the Hot Pot.
4. Plug cord into a 120 V AC outlet. Press the On/Off Switch to On.
The unit may emit an odor and/or smoke during the first few
uses from oils used in manufacturing. This is normal for a new
appliance.
5. Lift Lid up and away from the Hot Pot. To avoid escaping steam,
approach the Hot Pot from behind the Handle. Grasp the Handle
with one hand. Grasp the Lid Knob with the other hand. Check
to see if food or liquid is boiling.
WARNING: If the Hot Pot has been in use, it may be full of steam,
which will escape as soon as the Lid is opened. Keep hands, face,
and etc. clear of the area above the Hot Pot. Wear oven mitts when
using the Hot Pot.
6. When food or liquid boils, press the On/Off Switch to Off.
7. Unplug from wall outlet.
NOTE: Some sparks may be visible while disconnecting plug from
wall outlet. This is normal.
8. Slowly pour water out of the Hot Pot.
9. Lift the front of the Lid and move slightly forward. Then lift the
Lid up and away from the Hot Pot.
10. To avoid the risk of splashing, pour slowly and do not over-tilt the
Hot Pot.
5
TMR_TMHP4_IB_9-2-07 2/9/07 4:39 PM Page 6