Filter
Top Products
Before Using for the First Time
Boil a Kettle of water following the Operating Instructions below.
Discard the water.
Operating Instructions
5.
Figure 2
CAUTION: Do not immerse
Power Base, power cord, or plug
in water or any other liquid.
1. Place Power Base on a level
surface such as a countertop
or table.
The Power Base must be dry
before use.
2. Raise the ON/OFF Lever
into the OFF position. (See
Figure 2.)
3. Remove Kettle from the
Power Base by lifting up.
4. Open the Lid by pressing
down the Lid Release Button
located over the handle. (See
Figure 3.) Fill the Kettle with
the desired amount of water
while continuing to press the
Button. DO NOT fill ABOVE
the MAX level or BELOW
the MIN level as indicated on
the Water Window. Release
Button to lower Lid. Wipe
excess water off the Kettle.
CAUTION: Do not fill above
the MAX water level. This
could cause boiling water
to splatter out.
NOTE: If the Kettle is
accidentally switched ON
without sufficient water, a
boil-dry protection device
will automatically turn the
unit OFF. (See boil-dry
protection explanation.)
Figure 3
TMR_TMJK1CAN_IB_9-8-05 8/9/05 10:28 PM Page 5