Filter
Top Products
9.
8.
Personal Blender Use and Care Guide
6. Do not allow the Blade Assembly to soak in water for long periods
of time.
7. For quick clean-ups, the interior of the Blending Jar can be
cleaned by turning the Blender ON and OFF for several short
bursts. The unit will clean itself, without you having to handle
the sharp Blades. Unplug the Blender, rinse and dry thoroughly,
being careful as the Blades are sharp.
8. Properly reassemble all parts before storing.
STORAGE
CAUTION: Always assemble clean and dry Blender parts correctly
before storing on the Motor Housing. Severe injury can result if
Blender is accidentally turned ON when not properly assembled.
Unplug and clean unit. Store in original box or in a clean, dry place.
Never store Blender while it is hot or plugged in. Never wrap cord
tightly around the appliance. Never place any stress on cord, especially
where the cord enters the unit, as this could cause the cord to fray
and break.
◆ DO NOT put more than 7 ounces of hot ingredients into the
Blending Jar before beginning to blend.
◆ After the blending process has begun, you may slowly add up
to an additional 7 ounces of hot ingredients through the center
hole in the Lid.
◆ Always use a vessel with a pouring spout when adding hot
ingredients.
User Maintenance Instructions
This appliance requires little maintenance. It contains no user
serviceable parts. Do not try to repair it yourself. Any servicing that
requires disassembly other than cleaning must be performed by a
qualified appliance repair technician.
CAUTION: Never immerse the Motor Housing, plug or cord in water
or any other liquid.
1. Always unplug the unit before cleaning.
2. Whenever possible, rinse parts immediately after processing to make
cleanup easier.
CAUTION: Use extreme care when handling the Blade Assembly.
Do not touch the Blades with your fingers. The Blades are very
sharp and can cause injury if touched.
3. Wash the Blending Jar, Lid, and Cap in warm soapy water. Rinse and
dry thoroughly. Never use rough scouring pads or abrasive cleansers
on any plastic or metal parts as the surface may be damaged. Do not
wash the Lid, Cap and Blending Jar in the dishwasher.
4. If necessary, wipe exterior surface with a moist cloth or sponge and
dry thoroughly.
5.
Do not fill the Blending Jar with boiling water or place any of the
parts in boiling water.
TMR22RCAN Manual 8/17/05 2:36 PM Page 8