Filter
Top Products
13
Thread Comes Out Of Tension Control While
Sewing
Check that flow of thread from bobbin or spool is correct. (See
page 10)
HandyMender Does Not Run Or Runs Slowly After
Pressing Power Switch
(1) Check power connection.
(2) Check if batteries are installed correctly.
(3) Check for weak batteries.
(4) Check if normal thread spool is being squeezed by spool cap.
(5) NOTE: Thicker fabric will be slower.
QUESTIONS?
If you have questions about any aspect of threading or
mending with the HANDYMENDER call:
Customer Support
Contact our Customer Support Team at Top Innovations, Inc. at 1-
800-711-6617 or 1-816-584-9700. E-mail us at
mail@mitcoproducts.com or visit our web site at
www.mitcoproducts.com
14