Filter
Top Products
6 Topcom Butler S100
Topcom Butler S100
6.4 Setting the speaker ON/OFF
If you only want to use the blinking LED (visual indicator) and not the speaker, turn the
speaker switch to the left; = OFF.
6.5 Setting the ring tone
Press the tone button repeatedly until the desired ring tone is heard (1-9). The ring tone
will be stored automatically until you press the tone button again.
7 Troubleshooting
8 Technical Data
Range (base depending): up to 300 m in open space
up to 50 m in buildings
Batteries: 3 x 1.2V, 2200 mAh AA Type NiMH rechargeable
Max. standby time: approx. 400 hours
Ring sound: 85dBA max.
Ambient temperature: +5 °C to +45 °C
Permitted relative air humidity: 25 to 85 %
Power supply adapter: 220/230V, 50 Hz
6VDC 300mA
Problem Possible cause Solution
Green LED blinking Out of range
Not registered
Put the unit closer to the base
Make sure the unit is registered
on a DECT base
Ringer volume too low or no
ring sound
Selected ring tone not
ideal
Speaker switched OFF
Adjust the ringer tone, some
tones are clearly hearable then
others, the volume cannot be set!
Make sure the speaker switch is
turned ON
Cannot register Base has no free
handset anymore
Base system pin is not
‘0000’ or ‘1111’
Base is not in
registration mode
Remove one registered handset
from the base
Make sure the system pin of your
base is set to ‘0000’ or ‘1111’
See you base/telephone manual
how to put it into registration
mode