Filter
Top Products
NOTE: Some models (model numbers
beginning with “UR” and single section
dual-temps) require provision of a bot-
tom mounted condensate evaporator.
Follow instructions provided with part,
along with this for installation.
II. Operation:
Most Traulsen equipment is plug and play, such as G Series & most Com-
pacts. However, once power is supplied to the unit, some may require
simple steps to get started using your Traulsen equipment, such as the:
R & A Series/TE Series/TU Series/TS Series Cabinets
Although fully operational the control will flash the cabinet temperature
alternatively with the message ELE LOS (power loss). Press the alarm
cancel button to cancel this message.
R & A Series Control TE/TU/TS Series Control
Hot Food Holding Cabinets
Are shipped in the Off position. To begin use, first press the ON/OFF
button , and then adjust to the desired operating temperature using
the UP/DOWN buttons.
Hot Food Control
G Series/Compact Cabinets
Are fully operational and no action is required to start. Please note, most
compacts are equipped with a electromechanical control.
Compact Cabinets (electromechanical)
The temperature is set at the factory but local conditions may neces-
sitate slight adjustment. The temperature control is located in the front
of the evaporator housing. To adjust, turn the adjustment screw with
a screwdriver a small amount at a time; turning clockwise lowers the
temperature. An “OFF” position is fully counterclockwise and inter-
rupts power to the compressor and condenser fan only, not the entire
refrigerator.
I. RECEIPT & SUPPORT INSTALLATION:
You should carefully inspect your Traulsen unit for damage during delivery.
If damage is detected, you should save all the crating materials and make
note on the carrier’s Bill Of Lading describing this. A freight claim should
be filed immediately.
After uncrating the unit, select a level location for final placement. Install
the legs or casters as shown below or, in the case of roll-in and roll-thru
models, these must be sealed to the floor in accordance with local health
codes.
R & A Series/G Series Supports (“Stem” type legs)
TE/TU/TS Series Supports
Compacts Supports (“Stem” type legs & casters)
All models (except undercounters) should be installed to allow at least 12”
of clear space above the unit. In all cases the louvers must be free of any
obstruction which could prevent proper air-flow.
Most units are supplied with a cord and plug, which can simply be
plugged into a dedicated appropriately sized outlet. For those requiring
hard-wiring directly to the power supply, this should be done by only a
qualified electrician.
Instructions for the installation, use & care of:
R & A Series
G Series
Compact Undercounter & Prep-Table
TE Series/TU Series/TS Series
Quality Refrigeration
OWNER’S MANUAL
TR35924 P/N 375-60293-00 (rev. 3-11)