Filter
Top Products
1. When a probe reaches target temp (37°F)
an alarm will sound for 30-seconds. The
display the will continuously ash DONE.
2. Press the button alongside the probe
ashing DONE.
3. The print menu will appear. Press...
- RECORD to receive a paper printout.
- LABEL to receive an adhesive label.
- BOTH to receive both a paper printout
and adhesive label.
4. Repeat for additional probes.
5. Press NONE when complete to select next
probe or return to Main Menu (after last
probe).
6. Properly sanitize probes prior to next use.
Ending The Cycle/Printing
5 TRAULSEN RBC50, RBC100 & RBC200 BLAST CHILLER TRAINING GUIDE
Printing
Paper
Cycle
Data
Printout
Adhesive
Cycle
Data
Label
PRINT PROBE #1
RECORD
LABEL
NONE BOTH
Changing The Paper and/or Label Rolls
1. Access printer,
remove paper roll
and place a new
roll on the spindle
2. Lift feed roller
tension arm
3. Place paper edge
into the printer at
the feed roller
4. Close feed roller
tension arm then
press the red
button to load
paper
NOTE
Load paper with thermal side facing up.
PAPER:
Traulsen P/N 400-60003-00 • Ofce Depot #302-224 • Staples #PMF-5233
The label printer uses a special peel-off label stock, Traulsen part number 400-60004-00.
Each roll contains 225 labels.