Tricity Bendix BD 931 Oven User Manual


 
THINGS YOU NEED TO KNOW
WARNINGS:
This cooker must be installed by a qualified
electrician/competent person. Safety may be
impaired if installation is not carried out in
accordance with these instructions.
This cooker must be earthed.
Do not remove the screws from the earth tab
extending from the oven mains terminal block
(Fig. 6).
Before connecting the cooker make sure that the
voltage of your electricity supply is the same as
that indicated on the rating plate. The rating plate
can be seen by opening the oven door and
looking below the oven door seal.
Do not alter the electrical circuitry of this cooker.
THINGS TO NOTE
This cooker is designed to be fitted in cabinets of
the recommended dimensions as shown in Fig.
2. If your cabinet interior dimension is between
565-570mm the oven may still be fitted. However
a minor modification to the cabinet will be
required.
The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
Enquiries regarding the installation of the cooker
point if required should be made to your Regional
Electricity Company to ensure compliance with
their regulations.
The cooker point should be within 2m of the
cooker to make it accessible to switch off the
cooker in case of an emergency.
To protect the hands wear gloves when lifting the
oven into its housing.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried
out before the cooker is connected to the mains
supply and re-checked after fitting.
GETTING THINGS READY
CHOICE OF ELECTRICAL CONNECTION
There are three possible ways to connect your
cooker. In each case the cooker should be
operated using at least 6mm² twin core and earth
PVC insulated multicore cable. Please choose
from the most appropriate after reading the
descriptions:
a) By connecting the cooker to a cooker point
having a double pole isolating switch with at least
3mm contact separation in all poles and neutral,
and protected with a fuse or miniature circuit
breaker at your mains fuse box.
b) By connecting the cooker together with a hob box
directly to a cooker point(s). Having a double
pole isolating switch with at least 3mm contact
separation in all poles and neutral.
c) If you wish to connect an oven and a hob to a
cooker point you can by connecting the oven and
hob separately to the cooker point. Oven and hob
units should be separately connected to a control
panel. See Fig. 1.
NOTE: It is good practice to:
Fit an Earth Leakage Circuit Breaker to your
house wiring.
Wire your appliance to the latest IEE regulations.
PREPARING CABINET FOR FITTING OVEN
Make sure the cabinet is the correct size for the
appliance to be fitted (Ref. Fig. 2).
If the size is between 565-570*mm, then the
cabinet should be modified so that at the screw
fixing points the recommended dimension of at
least 560-565mm is maintained. The modification
should ideally be localised to ensure that after
screw fitment the oven is securely fixed into
position.
The cabinet must be stable and level by firmly
securing it to the wall or floor. If necessary, make
arrangements to ensure the shelf upon which the
oven will rest is level.
8
Subject to Regional Electricity Company
regulations if you wish to connect the oven
and hob to the power supply you may use
one of the following two methods:-
INSTALLATION INSTRUCTIONS
Fig. 1