Filter
Top Products
9
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it
under a close fitting sink unit or a pre-existing top,
providing the dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by unscrewing the two
rear retaining screws, pull from the front and slide out
the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with
the adjustable feet. When inserting the machine, ensure
that the water inlet and drain hoses are not kinked or
squashed.
Levelling
Good levelling is essential for correct closure and sealing
of the door.
When the appliance is correctly levelled, the door will not
catch on the levelling spacers on either side of the
cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
820
570 - 600
600
IN05
IN06
IN07