Tricity Bendix DH 103 Dishwasher User Manual


 
5
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (C)
(position 1 minimum dosage, position 6 maximum dosage).
Increase the dose if there are drops of water or lime spots on
the dishes after washing.
The dose is factory set in
position 5.
Reduce it if there are sticky
whitish streaks on the dishes.
Top up with rinse aid when:
1. The indicator (B) becomes clear,
2. Only for dishwasher models with rinse aid indicator
light:
When the rinse aid indicator light on the control panel
illuminates (when the machine is switched on).
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Use of detergent
Only use detergents specifically designed for use in
dishwashers.
We recommend the use of Finish detergents.
Using no more then the correct amount of detergent
contributes to reducing pollution.
Prior to the start of a wash programme (not for the "Rinse and
Hold" programme). The detergent is released during the
washing phase.
Please observe the manufacturer’s dosing and storage
recommendations as stated on the detergent packaging.
Fill with detergent
(Detergent dispenser type A)
1. If the lid is closed: press release button (1).
The lid springs open.
2. Fill the detergent dispenser (2) with detergent.
The marking indicates the dosing levels:
20 = approximately 20 g of detergent
30 = approximately 30 g of detergent
3. All programmes with prewash need an additional detergent
dose (5/10 g) that must be placed in the prewash detergent
chamber (3). This detergent will take effect during the
prewash phase.
4. Close the lid and press until it locks in place.
Fill with detergent
(Detergent dispenser type B)
1. Open the dispenser by pulling the catch (D).
The lid springs open.
2. Fill the detergent dispenser with detergent.
The marking indicates the dosing levels:
Min = approximately 15 g of detergent
Max = approximately 30 g of detergent
3. Close the lid and press until it locks in place.
4. All programmes with prewash need an additional detergent
dose (5/10 g) that must be placed over the lid of the
dispenser. This detergent will take effect during the prewash
phase.
BR11
BR03
BR02
DE19
DE22
DE17
DE02