Filter
Top Products
Use minimal, if any, extra oil or fat when
roasting meat, potatoes only require brushing
with fat before cooking. Extra fat in the oven
during roasting will increase splashing and
soilage.
It is not necessary to add water to the meat
tin when roasting. The water and the fat
juices from the joint create excessive
splattering during cooking, even at normal
temperatures, as well as causing
condensation.
Covering joints during cooking will also
prevent splashing onto the interior surfaces.
Removing the covering for the last 20-30
minutes will allow extra browning if required.
Some large joints and turkeys especially
benefit by this method of cooking, allowing
the joint to cook through before the outside is
overbrowned.
Do use the trivet in the roasting tin. During
roasting the fat from the joint will be
contained beneath the trivet and therefore
prevent it from splattering onto the Stayclean
finish.
REPLACING AN OVEN LIGHT
BULB
The type of bulb required is a 300°C, 25 watt
small Edison Screw.
1.Make sure the cooker is cool before you
replace a bulb.
2.Open the oven door and remove the shelves
and wirework runners.
Instructions on how to remove the wirework
runners are given on page 31.
3.Pull the glass bulb cover towards you and
then pull it off. If necessary use a screwdriver
to carefully lever off the cover, taking care not
to damage the oven cavity.
4.Unscrew the bulb by turning it to the left.
5.Fit a new bulb and then replace the glass
bulb cover.
6.Refit the wirework runners and replace the
oven shelves.
7.Restore the cooker to the electricity supply
and reset the time of day.
33
Isolate the cooker from the
electricity supply before replacing
the bulb.