Tricity Bendix SB462 Oven User Manual


 
12
AUTOMATIC CONTROL
You can only use the automatic control for the main
oven. When you use the automatic controls for the
first time it’s probably best to choose a time when
you are at home. That way you can check to make
sure you’ve set everything correctly and you’ll feel
much more confident when you are away from home
in the future.
SETTING THE CONTROLS FOR
AUTOMATIC USE
This is very easy. All you have to do is work through
the steps below. The clock will work out the rest for
itself.
1 Is the electricity supply on?
2 Is the clock
showing the
correct time?
To adjust turn the selector knob
to ‘Manual’ then to ‘Time
Setting’. Turn the setting knob in
either direction.
3 How long
will the food
take to cook?
Turn the selector knob to ‘Cook
Time’. Then turn the setting knob
until the length of time you want
the food to cook shows in the
display. The maximum cooking
time is 10 hours. ‘Auto’ will
show in the display.
4Whattimedo
you want the
food to be
cooked by?
Turn the selector knob to ‘End
Time’. Turn the setting knob
until the time the oven is to
switch off shows in the display.
The cookpot ( ) will go out.
The ‘End Time’ must not be
more than 23 hours 59 minutes
from the time of day. For
example if the time of day is 9.00
am the latest ‘End Time’ will be
8.59 am the next day.
5Setto
automatic.
Turn the selector knob to
‘Automatic’.
6 Turn on the
oven control.
Turn the oven control to the
required setting.
The time shown on the right gives an example of
setting the automatic controls when the time is 9.00
am, the food is to be cooked for hours and the
food is needed at 6.00 pm (1800 hours).
The clock will work out what time the oven will switch
itself on and it will turn the oven off at the end. Once
the automatic sequence is finished there will be an
alarm to remind you that you need to set the oven for
manual operation. To do this turn the selector knob
to ‘Manual’. Turn off the oven control.
If you change your mind and want to cancel a
programme that you have set simply turn to ‘Time
Setting’ and then to ‘Manual’.