Filter
Top Products
30
WARNING!
If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local service force
centre who will be pleased to advise further.
To replace the door glass
To ensure the glass is properly located the text
should be facing towards you at the top edge of
the door and facing into the cavity.
Holding the glass with both hands, gently slide
the glass into the side trims of the oven door.
Always ensure that the glass is returned to the
same side trim it was removed from.
To replace the trim, line up the clips on the
underside of the trim with the connectors at the
top of the door.
Carefully slide the trim towards the door.
Ensure the trim is securely in place before
closing the oven door.
WARNING!
Do not attempt to use the oven without the
glass being in place.
To clean the glass door panels
Clean the inner glass door panels using hot
soapy water, hob cleaner may also be used. Do
not use hob cleaner on the stainless steel or
painted surfaces. Ensure that all parts are well
rinsed and thoroughly dried before attempting to
replace the glass.
Replacing an oven light bulb
• The type of bulb required is a 300°C 25 watt
small Edison Screw.
WARNING!
Disconnect the appliance from the electricity
supply before replacing the bulb.
• Make sure the appliance is cool before
replacing the bulb.
• Open the door and remove the shelves.
• Remove the glass cover by turning it to the
left.
• Unscrew the bulb by turning it to the left.
• Fit a new bulb and then replace the glass
bulb cover.
• Replace the shelves.
• Restore the electricity supply and reset the
time of day.