Filter
Top Products
8
Problem
No power to the
appliance
The temperature in the
appliance is too high
The temperature in the
appliance is too low
Excessive frost and ice
has built up
The appliance is noisy.
Possible Cause
No power at the socket.
There is a power cut.
The fuse has blown.
Thermostat control is set at 0.
The appliance is located in an unsuitable position.
The thermostat control is set too low.
The thermostat control is set too high.
The door has been left open.
Something is obstructing the door.
The door gasket is dirty.
The appliance is not level.
Solution
Check there is power at the socket.
Check there is not a power cut by checking the
household lights.
Check the fuse has not blown.
Check the thermostat.
Check the ambient temperature is within the
appliances operating limits of 16 °C to 32 °C.
Check that the thermostat is turned to the correct
setting relative to ambient conditions.
Set the thermostat to a lower position.
Check the door has not been left open.
Check nothing is preventing the door from closing.
Check the door gasket is intact and clean.
Check if the appliance stands stable (all four feet
should be on the floor).
Some
Some
thing N
thing N
o
o
t W
t W
or
or
king
king
If the appliance is not working correctly, please carry out the following checks before contacting your local
Tricity Bendix Service Force Centre.
If after the above checks your appliance still does not
operate correctly, contact your local Tricity Bendix
Service Force Centre.
Please note that it will be necessary to provide proof
of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the
above checks have been made, as the
engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
NEVER use detergents, abrasive powders,
highly perfumed cleaning products or wax
polishes to clean the interior as these will
damage the surface and leave a strong
odour.
External Cleaning
Wash the outer cabinet with warm soapy water.
When the appliance is not in use
When the appliance is not in use for long periods,
disconnect from the electricity supply, empty all foods
and clean the appliance, leaving the door open to
prevent unpleasant smells.
Defrosting
While the appliance is in operation the ice-making
compartment becomes progressively covered with
frost.
This frost, acts as an insulator and prevents the
cold from reaching the insulator food. The frost
should be removed whenever the thickness of the
frost exceeds 1/4. To carry out complete
defrosting proceed as follows.
Pull out the plug from the wall socket or turn the
thermostat control knob to the '0' position.
Leave the fridge and ice-making compartment
doors open, when defrosting is completed, dry the
appliance thoroughly. Remove any defrost water
collected in the tray.
Replace the plug in the socket or return the
thermostat to the initial position and, after letting
the appliance run for at least an hour, place the
food in the evaporator compartment.