Filter
Top Products
1115R, 1175R, 29R, 1175BEV 19
Figure 35
9. Relocate plastic spacer/bushing
(Figure 35)
on bottom
of door to the opposite side. Clean out bushing hole in
door bottom if necessary.
Figure 36
10. Place door on lower hinge pin. Align flat edge of top
hinge with outer edge of unit and fasten upper hinge
to unit (four screws)
(Figure 36)
. Partially tighten
screws until door is aligned.
11. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
12. Replace four plastic plugs removed in Step 4 into holes
on top of unit. Replace screws in holes in bottom of unit
on opposite side.
13. Replace the grille.
Model 29R
To reverse the door, perform the following:
Figure 37
1. Remove the control knob (Figure 37, 1) by pulling it
straight out, away from grille.
2. Remove two screws from grille
(Figure 37, 2)
and save.
3. Remove the grille and grille cap from unit.
Figure 38
4. Remove top hinge from cabinet (three screws)
(Figure
38)
. Hold door to keep it from falling.
5. Lift the door off the bottom hinge.
Figure 39
6. Remove bottom hinge from cabinet (two screws)
(Figure 39)
.
1
ULIN_0109_A
ULIN_0110_A
2
1
ULIN_0197_A
ULIN_0143_A
ULIN_0121 _
A
ULIN_016357_30087.fm Page 19 Tuesday, March 14, 2006 2:36 PM