Filter
Top Products
U-Line Product Operation 5
1
3
5
4
2
4 Product Operation
Air Flow
IMPORTANTIMPORTANT
The unit requires proper air flow to perform at its highest
efficiency. Do not block the front grille or internal fans at
any time, or the unit will not perform as expected. Do not
install the unit behind a door.
To turn the unit on or off, press and hold the ON OFF button (2)
for about ten seconds and release. The display will show the unit
set-point temperature when turned on and display OFF when the
unit is off.
Electronic Control Panel
Digital Display. Wine Captain Models provide three
temperature zones within the cabinet to satisfy the specific storage
requirements of your finest wines.
The electronic control with digital display shows a single
continuous set-point temperature. This set point is for the middle
zone, it is a base number used by the controller to maintain the
multiple temperature zones in the unit. The factory default set-
point for Beverage Center and Refrigerator models is 38°F. The
factory default set-point Wine Captain models is 50°F. The set-
point temperature is a gauge for further temperature adjustments.
Turning the Display Off. Wine Captain Models and Beverage
Centers have a DISPLAY OFF mode available through the control
panel. This allows you to control if the display (3) will be ON or
OFF with the door closed. The button sequence that follows will
switch between both modes, On or Off:
1. Press and hold the WARMER button (4), and simultaneously
within five seconds press the ON OFF button (2) three times.
2. The display will be either visible or dark with the door closed.
To return to the previous mode, repeat Step 1.
Adjusting AirTemperature
IMPORTANTIMPORTANT
Adjust the set point temperature in single increments,
and wait 24 hours for the temperature to stabilize before
rechecking.
To adjust the set point temperature:
1. Press and release either the WARMER (4) or COOLER (5)
button to put the controller in the SET TEMPERATURE mode.
The display (3) will begin to flash the °F (or °C) symbol.
NOTE: This mode will self-cancel in five seconds, and the
display (3) will show the original set-point temperature.
2. Within five seconds (while the °F (or °C) symbol is flashing),
press the WARMER or COOLER button as required to adjust
the set point temperature.
3. The change sets five seconds after adjusting the temperature,
and the display (3) will show the new set-point temperature.
Temperature °F °C Selection. U-Line products supplied for
110 VAC have temperatures displayed (3) default in Fahrenheit
(°F). Models supplied for 220 VAC have temperatures displayed
(3) default in Celsius (°C).
Easily adjust the display for either type temperature display.
Press and hold the LIGHT button (1) and simultaneously within
five seconds press the COOLER button (5) three times to
change the display (3) as needed.
Temperature Display. The digital display shows set-point. air
temperature. Under normal operating conditions the
temperatures will fluctuate based on a number of factors including
door openings, product load, room temperature, and humidity. On
passive cooled units the temperature will always be cool toward
the top and coolest toward the bottom.
To display actual temperature:
1. Press the WARMER button (4) for five seconds. The display (3)
will indicate the actual temperature.
2. After about 10 seconds, the set point temperature will return to
the display.
Initial Startup
All U-Line controls are preset at the factory. Initial startup requires
no adjustments.
IMPORTANTIMPORTANT
U-Line recommends allowing the unit to run overnight
before loading refrigerator or freezer with product.