Filter
Top Products
10 75F
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary
(Figure 9)
.
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level.
Door Alignment Check and Adjustment
IMPORTANTIMPORTANT
Properly aligned, the door’s gasket should be firmly
in contact with the cabinet all the way around the
door (no gaps). Carefully examine the door’s gasket
to assure that it is firmly in contact with the
cabinet. Also make sure the door gasket is not
pinched on the hinge side of the door.
Figure 10
NOTE: It may be necessary to remove the grille to access
lower hinge screws.
1. Loosen (do not remove) top (Figure 10) and bottom
hinge screws.
2. Align door squarely with cabinet.
3. Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4. Tighten bottom hinge screws.
5. Tighten top hinge screws.
Door Reversal
To reverse the door, perform the following:
Figure 11
1. Remove grille unit.
2. Remove top hinge from cabinet (four screws)
(Figure
11)
. Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
Figure 12
4. Remove four plastic plugs
(Figure 12)
in hinge holes,
top of cabinet, opposite side. Be careful not to scratch
cabinet.
Figure 13
ULIN_0104_A
ULIN_0104_A
ULIN_0105_A
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0106_A
ULIN_016357_30144.fm Page 10 Tuesday, March 14, 2006 2:34 PM