U-Line CLR2160 Ice Maker User Manual


 
18 CLR2160, CLRCO2175
Door Shelf Removal/Insertion
Figure 28
To remove the door shelf:
1. Grasp shelf in center, lift slightly, and tilt 15°-20°.
2. Carefully pull shelf off bosses
(Figure 28, 2)
.
To install the door shelf:
1. Holding shelf in center, align notches (Figure 28, 1) in
shelf with bosses (Figure 28, 2) in door.
2. Tilt shelf at a 15°-20° angle and slide onto bosses at the
desired location.
Glass Shelf Removal/Installation
Figure 29
1. Pull shelf out about 6" (Figure 29, 1) until back of
shelf clears the "hump" on the right-hand side.
2. Tilt right-hand edge of shelf up.
3. Remove shelf from unit by pulling out
(Figure 29, 2)
.
Insert the shelves as follows:
1. To move to a different position in the unit, insert shelf
at an angle, approximately 15-20°, over the rib in the
side of the unit where you want to place the shelf. The
shelf must be started into the unit at an angle to clear
the door.
2. Continue to slide the shelf into the unit at an angle
until it clears the door.
3. Lower the shelf and push it in completely.
1
2
ULIN_0039_A
ULIN_0276_A
1
2