Filter
Top Products
CO29, CO75 15
Figure 25
6. Relocate plastic spacer/bushing
(Figure 25, 1)
on
bottom of door to opposite side, and place door on
bottom hinge pin. Clean out bushing hole in door
bottom with a screwdriver if needed.
Figure 26
7. Remove plastic hole plug from door handle and
relocate on opposite side
(Figure 26)
.
8. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge
(Figure 26)
.
Figure 27
9. Remove three plastic screw plugs in hinge holes, top of
cabinet, opposite side, being careful not to scratch
cabinet
(Figure 27)
.
10. Place door on lower hinge pin. Invert and install upper
hinge on door.
Figure 28
11. Fasten upper hinge to unit (three screws)
(Figure 28)
.
Partially tighten screws until door is aligned.
12. Adjust door to assure proper seal. Tighten upper hinge
screws securely.
13. Replace three plastic plugs removed in Step 10 into
holes on top of unit. Replace screws in holes in bottom
of unit, opposite side.
14. Re-inspect door seal and alignment. Adjust if needed.
Figure 29
15. Make sure grille cap is behind grille in slots provided in
grille
(Figure 29, 1)
before attaching grille to unit, and
secure but do not overtighten both grille screws
(Figure 29, 2)
.
16. Install the temperature control knob.
All units may be left- or right-hand opening.
1
ULIN_0109_A
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0142_A
ULIN_0144_A
ULIN_0145_A
ULIN_0214_A
1
2
ULIN_016357_30089.fm Page 15 Monday, March 27, 2006 10:25 AM