Filter
Top Products
3 U-Line Product Operation
123 54
3 Product Operation
Air Flow
IMPORTANTIMPORTANT
The unit requires proper air flow to perform at its highest
efficiency. Do not block the front grille or internal fans at
any time, or the unit will not perform as expected. Do not
install the unit behind a door.
To turn the unit on or off, press and hold POWER (1) for about
ten seconds and release. The display will show the unit set-point
temperature when turned on and display OFF when the unit is off.
Electronic Control Panel
Digital Display.
The electronic control with digital display shows a single
continuous set-point temperature. The factory default set-point
for Glass Door Refrigerators and Refrigerator models is 38°F. The
factory default set-point for Wine Captain® models is 50°F. The
set-point temperature is a gauge for further temperature
adjustments.
Turning the Display Off. Wine Captain® Models and Glass
Door Refrigerators have a DISPLAY OFF mode available through
the control panel. This allows you to control if the display will be
ON or OFF with the door closed. The icon sequence that follows
will switch between both modes, On or Off:
1. Press and hold WARMER (2), and simultaneously within five
seconds press POWER (1) three times.
2. The display will be either visible or dark with the door closed.
To return to the previous mode, repeat Step 1.
Adjusting Air Temperature
IMPORTANTIMPORTANT
Adjust the set point temperature in single increments,
and wait 24 hours for the temperature to stabilize before
rechecking.
To adjust the set point temperature:
1. Press and release either WARMER (2) or COOLER (4) to put
the controller in the SET TEMPERATURE mode. The display
(3) will begin to flash the °F (or °C) symbol.
NOTE: This mode will self-cancel in five seconds, and the
display (3) will show the original set-point temperature.
2. Within five seconds (while the °F (or °C) symbol is flashing),
press WARMER or COOLER as required to adjust the set point
temperature.
3. The change is committed five seconds after adjusting the
temperature, and the display (3) will show the new set-point
temperature.
Temperature °F °C Selection. U-Line products supplied for
110 VAC have temperatures displayed (3) default in Fahrenheit
(°F). Models supplied for 220 VAC have temperatures displayed (3)
default in Celsius (°C).
Easily adjust the display for either type temperature display.
Press and hold LIGHT (1) and simultaneously within five
seconds press COOLER (5) three times to change the display
(3) as needed.
Temperature Display. The digital display shows set-point. Under
normal operating conditions the temperatures will fluctuate based
on a number of factors including door openings, product load,
room temperature, and humidity. On passive cooled units the
temperature will always be coolest toward the bottom.
To display actual temperature:
1. Press WARMER (2) for five seconds. The display (3) will
indicate the actual temperature.
2. After about 10 seconds, the set point temperature will return to
the display.
Initial Startup
All U-Line controls are preset at the factory. Initial startup requires
no adjustments.
IMPORTANTIMPORTANT
U-Line recommends allowing the unit to run overnight
before loading refrigerator or freezer with product.