Filter
Top Products
QUICK START GUIDE
7
u-line.com
2200 SERIES ZWC
First Use
All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends allowing the unit to run
overnight before loading with product.
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, simply press and the unit will immediately
switch on. To turn the unit off, press .
Up Down Light Power Auxiliary
Alert
LED
CONTROL FUNCTION GUIDE
FUNCTION COMMAND DISPLAY/OPTIONS
ON/OFF Press and release Unit will immediately turn ON or OFF.
Toggle lights Press and release Leave interior light on for 3 hours.
Adjust temperature
Press and release
The zone you are setting will have its light turned on
(top zone first).
Press to adjust set point
temperature
Display will show the set temperature.
Press to change zones Light will switch from top zone to the bottom zone.
Press to adjust set point
temperature
Display will show the set temperature.
Press to confirm and exit
View temperature in unit Press together and release
The display will flash and then toggle from set point
to temperature in unit. The temperature shown will
correspond to the illuminated zone.
Toggle between F/C Hold for five seconds The display will change units.
or
or
or
and
and