u-line.com 13
Remove Stainless Frame
1. Remove two screws from top of door. Save screws for later
installation.
2. Remove pivot plate from bottom of door by removing 2 screws.
Set pivot plate and screws aside for later installation.
3. Grasp outer edge of stainless frame and firmly press inside edge
of glass in while pulling stainless frame in opposite direction.
4. Unhinge frame from door.
Assemble Stainless Frame
1. Prop frame against solid surface, handle side down and away.
2. Insert door, logo forward, into frame at a 30° angle. For a right
hand hinge the logo should be to your right. For a left hand hinge
the logo should be to your left.
3. Swing door into frame.
4. Install screws removed in “Remove Stainless Frame” step 1 to
top of door, opposite handle.
5. Install pivot plate to bottom of door, opposite of handle, using
hardware removed in “Remove Stainless Frame” step 2. Arrange
pivot plate so the flat edge is against the edge of the door.
Screws
Top Of Door
Pivot Plate
Screws
Bottom Of Door
Push Glass
In
Pull Frame
Away
Door Orientation Right Hand Hinge
Logo
Door Orientation Left Hand Hinge
Logo
Pivot Plate
Flat Edge
Door Edge