Filter
Top Products
u-line.com 11
Leveling
NOTICE
Unit must be level for proper door operation.
1. Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side edge
as shown (1).
2. If the unit is not level, rotate the adjustable leveling legs to raise or
lower each corner of the unit (2) as necessary.
3. To rotate rear leveler legs remove grille (plinth strip/base fascia).
See Removing and Installing Grille (Plinth Strip/Base Fascia) on page
11
.
4. Using the provided 6mm T bar Allen wrench, rotate the 2
adjustment screws as shown below.
5. Check levelness after each adjustment and repeat the previous
steps until the unit is level.
Removing and Installing Grille (Plinth
Strip/Base Fascia)
WARNING
!
• Disconnect electrical current to the unit before
removing the grille (plinth strip/base fascia).
• Edges of sheet metal may be sharp.
Removing the grille (plinth strip/base fascia).
1. Disconnect electrical current to unit.
2. Using the included 7/64" Allen wrench, loosen, but do not remove
both grille (plinth strip/base fascia) lock screws. See below.
3. Gently pull grille (plinth strip/base fascia) away from unit until it
stops.
4. Push grille (plinth strip/base fascia) rails towards the center of the
unit to lift rails off lock screws.
5. Pull grille (plinth strip/base fascia) free from unit.
Installing the grille (plinth strip/base fascia).
1. Align slots in
grille (plinth strip/base fascia)
rail with screw heads in
base of unit
2. Push grille (plinth strip/base fascia) rails towards the center of the
unit and set rails over screw head.
3. Slide grille (plinth strip/base fascia) into position. Using included
7/64" Allen wrench tighten grille (plinth strip/base fascia) lock
screws.
3000 Series Maintenance
1
2
Rotate Clockwise to raise rear leg
Rotate Counter-Clockwise to lower
Rotate Clockwise to raise rear leg
Rotate Counter-Clockwise to lower
Grille Mounting
Screws
Grille Rail