Filter
Top Products
ADJUSTMENT OF BOWL HEIGHT:
The distance (X) is measured from the bottom side of the
bayonet hole to the surface on the bowl arms on which the
bowl rests (fig.7a). The bowl arms must be lifted to normal
working position.
W30 = 6 3/8”
(X): W40 = 6 3/8”
W60 = 6 15/16”
Lower the bowl arms down on a wooden block so that the
weight of the bowl arms are not loading the lifting system.
Loosen the counter nut (1), (fig.7b). Take out the cotter pin
(2). Take out the lifting rod (3). The lifting bolt (4) is now
loose and can be turned out or into the lifting nut (5), until
the correct height of the bowl arms has been reached.
Fig.7A
ADJUSTMENT OF BOWL FIXING:
The bowl arms must be raised to normal working position.
Loosen the counter nuts (1) and remove the cotter pins (2).
Turn the bolt (3) until correct fixing of the bowl is achieved.
By turning the bolts out of the extension tube the fixing is
increased. Start by turning one of the bolts half a revolu-
tion.
ADJUSTMENT OF BOWL CENTERING:
Loosen the counter nuts (1) and remove the cotter pins (2).
Turn the bolt (3) until the bowl is in the center of the mixer.
In order not to after the fixing of the bowl, one of the bolts
must be turned out of the extension tube and the other into
the extension tube. Use the flat beater to check that the
bowl is correctly centered and turn the planetary head with
your hand before the voltage is connected.
7