Victory Refrigeration VR-1-G Refrigerator User Manual


 
3
Cabinet Cleaning
Victory Refrigeration recommends periodic internal and exterior cleaning as outlined below.
Daily Exterior Cleaning
1. Clean surface with a sponge and cleaning solution. Use a non-abrasive cleaner that does not contain chlorine.
2. Polish with a soft cloth, wiping with the grain of the metal.
3. Once a week wipe with a film cutting agent to maintain shine.
Weekly Interior Cleaning
1. Remove all food, food related items and shelves.
2. Turn the unit off.
3. Remove loose food particles from interior floors, walls and ceiling.
4. Scrub all interior surfaces with warm detergent solution 100 °F - 120°F (38°C - 39°C) and a nylon bristled brush.
5. Rinse with clear water and allow to air dry.
6. Reinstall shelves.
7. Return power (electrical) to unit by resetting circuit breaker.
8. Return food to cabinet when temperature indicator reaches safety zone.
Condenser Maintenance
To keep your cabinet running efficiently, it is recommended that you clean the condenser once every three months.
However, once a month is recommended if the unit is located near cooking equipment which produces grease laden
vapors, i.e. fryers, grills, steam kettles, etc.
1. Disconnect power by switching circuit breaker to “OFF” position.
2. Remove the front grill by removing the two (2) screws on the inside of the grill at each end, then lift the panel up
and straight out.
3. Use a vacuum cleaner with proper brush attachments to clean the condenser, motor-compressor and related parts.
4. In extreme cases of dust and grease buildup, the condenser fins may require blowing out with compressed air or
cleaning with a degreasing agent.
5. Turn circuit breaker to “ON” position.
WARNING: Failure to keep condenser clean may cause premature failure of motor-compressor which
will NOT be covered by warranty.
Lubrication
Unless otherwise specified, all Victory refrigerators are equipped with oilless type motors. The motor-compressor is a
sealed unit and is constantly lubricated when in operation. The condenser and the evaporator motors are equipped with
lifetime oiled bearings which never need to be oiled.
3
PERIODIC MAINTENANCE