Filter
Top Products
7
Attaching the Wood Frame to the Door (DFUR MODEL)
1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove
the door by angling the door off of the bottom hinge pin.
2. Peel back the door gasket to expose the screw holes.
3. Set the wood frame flush to the front of the door in the desired location. Clamp the wood frame to the door if
necessary.
4. Insert the wood screws through the back of the door into the pilot holes in the wood frame and tighten.
5. Reinstall the door gasket by pressing into the door channel. Make certain the corners are inserted fully.
6. Install the door to the unit. Use the supplied plastic washer as shown in the figure below.
7. Realigning the door may be necessary. Any final door adjustments can be made using a 1/8” allen head driver to
adjust the door’s hinges. (See figure below)
8. Attach the door light striker plate as shown using the 5/16” hex or phillips head screws provided. Make certain the
light is able to turn on and off when the door is opened and closed.
9. Attach the door to the unit by reversing step number 1 above.
Magnetic door
gasket
Rear of Door
Bottom of door
Attached wood frame
3/8” clearance
holes for
frame wood
screws -
10 holes
1/8” allen head screws for hinge
adjustment
Door hinge
adjustment screws
Door light striker plate
Attaching the Handle
Attach the handle of your choice by drilling mountingholes through panel. Countersink or counterbore holes from back
side of panle for handle screw heads to be flush
CAUTION
Door can become
disengaged if washers
are not installed.
CAUTION
Door can become
disengaged if
washers are not
i
nstalled.
Cabinet
Hinge
Wood
Frame
Door Hinge
Door Hinge
Shoulder bushing
3/4” OD x 7/16”
ID Washer
3/4” OD x 1/4” ID
Washer
(3) Nylon hardware
components at
bottom hinge
CAUTION
Door may not swing properly
if all nylon components are
not installed as shown
Bottom Hinge Cover
Wood Frame
HHiinnggee HHaarrddwwaarree IInnssttaallllaattiioonn
DDeettaaiillss
5/8”x 7/32” ID washer
Shoulder
bushing
(2) Nylon
hardware
c
omponents at
top hinge
Top Hinge Cover