Viking DGSU1004BSS Cooktop User Manual


 
12 13
Lighting Burners
All burners are ignited by electric ignition.
There are no open-flame, “standing” pilots.
Surface Burners-Automatic Reignition
To light the surface burners, push and turn the
appropriate control knob counterclockwise to
any position. This control is both a gas valve
and an electric switch. Burners will ignite at any “ON” position with the
automatic re-ignition system. If the flame goes out for any reason, the
burners will automatically reignite if the gas is still flowing. When gas is
permitted to flow to the burners, the electric igniters start sparking. On all
surface igniters you should hear a “clicking” sound. If you do not, turn
off the control and check that the unit is plugged in and that the fuse or
circuit breaker is not blown or tripped.
Rear and Front Burners
Push in and turn the control knob counter-clockwise to the desired setting.
The control knobs can be turned to any desired setting as the knobs do
not have fixed positions between “Hi” and “Simmer”.
Within a few moments, enough gas will have traveled to the burner to
light. When the burner lights, turn the burner control to any position to
adjust the flame size. Setting the proper flame height for the desired
cooking process and selecting the correct cooking vessel will result in
superior cooking performance, while also saving time and energy.
Note: The igniters may click a number of times before the burner ignites.
This is normal. All igniters will spark regardless of which burner is being
operated.
Surface Operation
Operation
Surface Operation
Surface Cooking Tips
The simmer line on the control panel is the beginning of the variable
simmer setting and produces a high simmer setting. Turn the knob
slowly towards “OFF” and the flame will adjust to a lower simmer
setting.
Use low or medium flame heights when cooking in cookware that are
poor conductors of heat, such as glass, ceramic, and cast iron. Reduce
the flame height until it covers approximately 1/3 of the cookware
diameter. This will ensure more even heating within the cookware and
reduce the likelihood of burning or scorching the food.
Reduce the flame if it is extended beyond the bottom of the cookware.
A flame that extends along the sides of the cookware is potentially
dangerous, heats the cookware handle and kitchen instead of the food,
and wastes energy.
Reduce the flame height to the minimum level necessary to perform the
desired cooking process. Remember that food cooks just as quickly at a
gentle boil as it does at a rolling boil. Maintaining a higher boil than is
necessary causes a loss in food flavor and nutrients.
Surface Heat Settings*
*Note: The above information is given as a guide only. You may need to
vary the heat settings to suit your personal requirements.
Heat Setting Use
Simmer
Melting small quantities
Steaming rice
Simmering sauces
Low
Melting large quantities
Med Low
Low-temperature frying (eggs, etc.)
Simmering large quantities
Heating milk, cream sauces, gravies,
and puddings
Med
Sautéing and browning, braising, and pan-frying
Maintaining slow boil on large quantities
Med High
High-temperature frying
Pan broiling
Maintaining fast boil on large quantities
High
Boiling water quickly
Deep-fat frying in large cookware
Operation