Filter
Top Products
Troubleshooting
Problem
Possible Cause and/or Remedy
Range will not function.
Range is not connected to electrical power:
Have electrician check power circuit breaker,
wiring, and fuses.
Broil does not work.
Temperature control knob is rotated too far
past broil position.
Oven light will not work.
Light bulb is burned out.
Range is not connected to power.
Igniters will not work.
Circuit is tripped.
Fuse is blown.
Range is not connected to power.
Igniters sparking but no
flame ignition.
Gas supply valve is in “OFF” position.
Gas supply is interrupted.
Igniters sparking
continuously after flame
ignition.
Power supply is not grounded.
Power supply polarity is reversed.
Igniters are wet or dirty.
Burner ignites but flame is
large, distorted, or yellow.
Burner ports are clogged.
Unit is being operated on wrong type of gas.
Air shutters not properly adjusted.
Strong odor and/or smoke
is noticed first few times
oven is used.
This is normal burn off of insulation and
protective oils in oven. This will go away
after using oven a few times.
Oven indicator light on;
oven will not heat
Oven is operating properly. Unit will resume
heating function once it has cooled.
Product Care
Product Care
Door Replacement and Adjustment
1
2
3
4
Reinstall door to range.
Open door completely.
Reinstall hinge trim on both sides.
Remove pins from holes in hinges.
5
If the door needs to be adjusted, loosen
hinge trim screws located in step 2. Adjust
the screws located between the door
and kickplate using a 5/32” hex head
allen wrench. After adjustment,
tighten hinge trim screws.
Close door.
38 39