Filter
Top Products
98
L
I
GHTS
ON
OFF
ON
O
FF
ON
O
F
F
F
A
N
H
EAT
LAM
P
ON
O
F
F
(Pro wall hoods only)
Blower speed knob
Heat lamp switches
LOW
LOW
HIGH
HIGH
LOW
LOW
HIGH
HIGH
Dimmer knob
Light switch
ON/OFF switch
Product Controls/Operation
Using Outdoor Hoods
• Outdoor hood models should be installed in a covered
yet non-enclosed area. They should also be protected from
natural elements (such as rain) as much as possible.
• Always turn the outdoor hood on to the “HIGH” position
before lighting the grill.
• Keep the grill canopy closed as much as possible when
cooking so smoke is exhausted from the back of the grill.
This allows for optimum performance of the hood.
• During breezy conditions, outdoor hoods may not perform
well.
Any piece of equipment works better and lasts longer when
maintained properly and kept clean. Ventilation equipment is no
exception. Your hood must be kept clean and maintained
properly.
Cleaning Baffle Filters
As air passes through a baffle filter, grease particles collect on
the stainless steel U-shaped baffle channels and drip down
into the bottom of the filter. Baffle filters are extremely
efficient when compared to mesh filters. The power of the
hood is increased as more air passes through a baffle filter
than with mesh filters, which are usually dirty. Baffle filters are
almost universally required in commercial installations due to
their superior ability to capture grease. The baffle filters
should be examined periodically to assure that all surfaces and
parts are clean. The filters can be washed in a dishwasher or in
a sink with hot, soapy water. Simple periodic cleaning will
ensure maximum filter effectiveness.
• Do not use caustic detergent to clean the filters. An abrasive
or corrosive cleaner may damage the finish.
• Do not take the baffle filters apart to clean them. It is not
necessary and will void the filter warranty.
CAUTION
Unplug power cords from control panel before cleaning
or servicing hood.
2
1
3
1
1
2
1
2
3
Slide filter forward off of rear lip. Lower
filter rear, then slide filter front out.
Slide filter forward off of rear lip. Lower
filter rear, then slide filter front out.
Product Care
Fan On/Off switch—Starts and stops the blower. When
turned on the blower will operate at the previous setting of
the speed control.
Blower speed knob—Turn the knob counterclockwise to
decrease the blower speed and clockwise to increase speed.
The type of cooking you are doing will dictate the speed of
the blower you use.
Light switch—Controls the 50-watt halogen lights located in
the front of the hood.
Dimmer knob—Turn the knob clockwise to brighten the
halogen lights and counterclockwise to dim the lights.
Heat lamp switches—Turn the heat lamps on and off.
Cleaning and Maintenance
Settings and Functions
10” H. Indoor and Outdoor Hood Control Panel